Piezoelectric force sensor SlimLine, ring force transducer (Fz 3 kN / 674 lbf) / 9130C21
- Piezoelectric force sensor SlimLine with a measuring range of Fz: 0 ... 3 kN
- Dimensions DxdxH: 8x2.7x3 mm
- Connector: KIAG 10-32 pos.
- Cable length: 2 m
Preloaded sensorNoMeasuring range0 … 3 kNMaximum measuring range3 kNForce sensor typeStandard force sensorRecommended preloading force0.6 kNNominal sensitivity with preloading set to approximately -8 percent–3.3±0.3 pC/NMaximum bending moment Mxy (single load)1.4 NmOperating temperature range ΔT-20 … 120 °CAxial stiffness1 kN/μmBending stiffness0.046 kNm/°Lateral stiffness0.2 kN/μmCalculated shear stiffness0.3 kN/μmCalculated torsonial stiffness0.052 kNm/°Insulation resistance≥10^13 ΩMass1 gCase materialDIN 1.4542Nominal sensitivity–3.6±0.3 pC/NOverload3.5 kNTemperature coefficient of sensitivity–0.02 %/°CLinearity≤±1 %FSOOutput signal typeCharge (Piezoelectric, PE)Degree of protection EN 60529IP65Cable length2 mApplicationsSpot welding process monitoring, NVH Testing, Spot welding process monitoring
Piezoelectric force sensor, also known as piezoelectric ring force transducer, with extremely flat design for precisely measuring compression forces. Maximum resolution capacity, high stiffness and extremely compact dimensions enable ideal installation in mechanical structures. The case is hermetically sealed and has an integrated, splash-proof connecting cable with connector. This piezoelectric force sensor SlimLine is supplied uncalibrated and must be calibrated in situ after mounting for absolute measurements.The force Fz to be measured acts on the piezoelectric force sensor via the preloaded or mounting structure and produces a charge that is directly proportional to the force. This is measured by an electrode integrated in the ring force transducer and fed to the charge amplifier via the integrated cable. Because of their exceptional stiffness, SlimLine sensors are especially well suited for measuring dynamic forces. Cyclic measurements or measurements over several minutes are also possible, however. The sensor is especially well suited for measuring forces in shunt mode. This means that the sensor is embedded and preloaded in a structure. As a result, it is loaded with only part of the process force. Its especially small size is ideally suited for installation in structures such as force plates, fitting strips and tools. The sensor is used in industrial production processes in which forces are monitored or measured. Used in combination with a ControlMonitor, the sensor is ideal for quality control and monitoring.
Piezoelectric force sensor SlimLine – Piezoelectric ring force transducers for tensile and compression forces from 3 kN to 80 kN
Piezo Kraftsensoren SlimLine – Piezoelektrische Kraftmessringe für Zug- und Druckkräfte von 3 kN bis 80 kN
Piezo Kraftsensor, Kraftmessring
Piezoelectric Force Sensors, Ring Force Transducers
圧電式力センサ、 産業用力センサ、 薄型力センサ
Industrial charge amplifiers for manufacturing applications (ICAM), 1 to 4 channels (±10 V / 4 … 20 mA)
Laboratory charge amplifiers, 1-channel, low noise, measuring ranges ±2 to ±2200000 pC, freq. range ≈0 … 200 kHz
Laboratory charge amplifiers, multi-channel, low noise, measuring ranges ±2 to ±2200000 pC, freq. range ≈0 … 200 kHz