This basic course gives an introduction to cavity pressure measurement in plastic injection molding and provides participants with information on the use of cavity pressure sensors for process optimization, process analysis and quality monitoring.
- Basics of cavity pressure measurement
- Use and positioning of cavity pressure sensors
- Relationship between cavity pressure and molded part quality in the injection molding process
- Separation of good and bad parts through cavity pressure
- Process analysis, process optimization and quality monitoring with cavity pressure
There will be practical exercises on an injection-molding machine in this course.
General information on Kistler training courses
Please send your registration/cancellation in writing to the contact person below. As attendance is limited, please send us your registration at the earliest possbile opportunity. The course fee covers all seminar documentation and refreshments during the course.
You may cancel your attendance without incurring charges up to three weeks before the start of the seminar. In the event of later cancelllation or failure to attend, we will charge you the full course fee.
Kistler reserves the right to cancel or amend the course for compelling reasons.
Registration and information
Mrs. Annette Rasch
Tel. +49 7031 3090 0
To enable participants to understand the fundamental relationships between cavity pressure, process and molded part quality and to have an overview of the use and handling of the different cavity pressure sensors.
Machine operators, production managers, toolmakers, tool designers, quality assurance specialists.
1 day (09:00 am – 4:30 pm)