Cavity pressure sensors, direct measuring (ø2.5 mm, 2000 bar) / 6159A

These piezoelectric cavity pressure sensors with a small front diameter are recommended for use in multi-cavity molds.

6159A

These piezoelectric cavity pressure sensors with a small front diameter are recommended for use in multi-cavity molds.
Main features / advantages
  • Pressure range: 0 … 2000 bar
  • Exchangeable single-wire or coaxial cable
  • Sensor front can be machined to adapt to the cavity wall
This quartz sensor for mold cavity pressure (Type 6159A) has a front diameter of 2.5 mm. An O-ring seals the annular gap of <10 µm between sensor and mounting bore, and thus also center-aligns the sensor in the bore. The pressure acts over the entire front of the sensor and is transmitted to the quartz measuring element, which produces a proportional electric charge (pC = Picocoulomb). This is converted into a voltage (0 … 10 V) in the amplifier and is then available as an amplifier output. All parts of the sensor are corrosion-resistant. The exchangeable cable is screwed to the sensor with a tight seal. For multi cavity applications the Type 6159A cavity pressure sensor is used without the single-wire connector Type 1839. This sensor is available with several types of connecting cables.
Data sheet
English
pdf
Please click here to log in to myKistler and you will be redirected.
Manual
Direct cavity pressure sensors
English
pdf
Please click here to log in to myKistler and you will be redirected.
Poster
English
pdf
Please click here to log in to myKistler and you will be redirected.
Quick start guide
Quick Start Installation 2,5 mm Cavity Pressure Sensor
English
pdf
Please click here to log in to myKistler and you will be redirected.