Multicomponent dynamometers, maximum forces up to 4 kN, cover plate 39x80 mm / 9119A

These piezoelectric multicomponent dynamometers are for measuring the three orthogonal components Fx, Fy and Fz of a force.

9119A

These piezoelectric multicomponent dynamometers are for measuring the three orthogonal components Fx, Fy and Fz of a force.
 
  • Small design
  • High sensitivity and natural frequency
  • Small temperature error
  • For cutting force measurements in ultra precise machining
  • For general multicomponent force measurement
  • Modular system with machine adapters and tool holders for turning processes
The dynamometers consist of four three-component force sensors mounted under high preload between the cover plate and the two lateral base plates. A low temperature error is obtained by this special mounting of the sensors. Each force sensor contains three crystal rings, of which one is sensitive to pressure in the y-direction and the two others to shear in the x- and z-directions. The forces are measured practically without displacement. The outputs of the four mounted force sensors are fed to the 9-pole flanged socket. There are also multicomponent force-moment measurements possible. The four sensors are fitted so that they are ground-isolated. This largely eliminates ground loop problems. The dynamometers are corrosion-resistant and protected against penetration by splashing water or cutting fluid. The dynamometers including connecting cable Type 1687B5 or Type 1677A5 meet the degree of protection IP67.
Folha de dados
Inglês
pdf
 
Inglês
pdf
 
Manual
MiniDyn Multicomponent Dynamometer up to 4 000 N
Inglês
pdf
 
MiniDyn Multicomponent Dynamometer up to 4 000 N Type 9119AA1
Inglês
pdf