Cavity pressure sensors, direct measuring (ø2.5 mm, 200 bar) / 6178C

Cavity pressure sensors, direct measuring (ø2.5 mm, 200 bar)

6178C

These piezoelectric cavity pressure sensors feature Unisens® (unified sensitivity).
 
  • Pressure range: 0 … 200 bar
  • Exchangeable cable
  • Sensor front can be machined to adapt to the cavity wall
  • IP67 waterproof
The Type 6178C cavity pressure sensor is a direct measuring piezoelectric sensor with a front surface of 2.5 mm diameter. Its front surface is installed with contact to the melt. For abrasive melts (e.g., glass fibers), a TiCN coated version is offered. On the uncoated versions, the front can be machined up to 0.5 mm to be flush with the cavity wall contour. For these types, it is possible to mount a keyway pin to prevent the sensor from rotating in the mounting bore. Type 6178C is delivered with unified sensitivity. The maximum deviations of the sensitivities are ±3% of the nominal sensitivity (12 pC/bar). This simplifies the interchangeability of sensors, as the nominal sensitivity can be used. All versions with replaceable cable are IP67 protected. Type 6178C is available in several different mounting styles, as well as different cable types, so that an easy and flexible integration in each mold environment can be achieved. The pressure acts over the entire front of the sensor and is transmitted to the quartz measuring element, which produces a proportional electric charge (pC = Picocoulomb). This is converted into a voltage (0 ... 10 V) when used with a charge amplifier.
6178C      
 
Cavity pressure sensor, direct measuring (ø2.5 mm, 200 bar)
Data sheet
English
pdf
 
German
pdf
 
Quick start guide
Quick Start Installation 2,5 mm Werkzeuginnendrucksensor
German
pdf
 
Quick Start Installation 2,5 mm Cavity Pressure Sensor
English
pdf
 
Quick Start Installation 2,5mm Werkzeuginnendrucksensor mit ladungsführender Distanzhülse
German
pdf
 
Quick Start Installation 2,5 mm Cavity Pressure Sensor with conductive spacer sleeve
English
pdf