Cavity pressure sensors for low-viscosity thermoset resins (max 200 bar) / 6162A
These robust piezoeletric cavity pressure sensors measure pressures up to 200 bar during processing of crosslinking molding compounds in various low-pressure methods for lightweight plastic construction in the automobile and aerospace industries.
- Suitable for industrial use with conventional and high pressure RTM, LSRs, and SMCs
- Sensitive diaphragm sensor welded into sleeve
- Interchangeable cable
These sensors consist of a sensitive ø4 mm diaphragm design welded into a robust ø6 mm sleeve. The welded ring gap prevents ingress of low-viscosity resins and falsification of the sensor signal by a force shunt. Interchangeable cables allow a choice of cable types and/or repairs. The pressure acts over the diaphragm front of the sensor and is transmitted to the measuring element, which produces a proportional electric charge (pC = Picocoloumb). This is converted into a voltage of 0 ... 10 V in the amplifier, and is then available as an amplifier output. These sensors are available in two versions for different types of cable. The coaxial version uses high-insulation cables that do not necessarily have to be laid in the mold. The practical, singlewire alternative is based on a cable that can be cut to any length. The cut-and-grip connector can be connected during mounting in the mold. This makes both installation and servicing easier.
Handbuch – Direkte Werkzeuginnendrucksensoren
Manual – Direct cavity pressure sensors
Quick start guide
Quick Start Installation 6 mm Werkzeuginnendrucksensor
Quick Start Installation 6 mm Cavity Pressure Sensor