Multicomponent dynamometer MiniDyn, 4 kN, cover plate 55x80 mm / 9119AA2

Multicomponent dynamometer MiniDyn, 4 kN, cover plate 55x80 mm
9119AA2
18017665
  • Piezoelectric multicomponent dynamometer with maximum forces Fx, Fy, Fz ±4 kN
  • Cover plate 55x80 mm
  • Natural frequency fn (x) 4.3 kHz, fn (y) 4.6 kHz, fn (z) 4.4 kHz
  • Fischer 9-pin flange connector
In stock
On request
Log in to myKistler to see prices
Measuring ranges
Minimum measuring range [kN]
-4 kN
Maximum measuring range [kN]
4 kN
Product type
Force sensor type
A dynamometer is a force plate measuring forces and moments.
Multicomponent dynamometer
Preloaded sensor
Preloaded sensors are already calibrated and therefore ready-to-use. Non-preloaded sensors are smaller.
Yes
Crosstalk
Maximum crosstalk Fx→Fy
-2 … 2 %
Maximum crosstalk Fx→Fz
-2 … 2 %
Maximum crosstalk Fy→Fx
-2 … 2 %
Maximum crosstalk Fy→Fz
-2 … 2 %
Maximum crosstalk Fz→Fx
-2 … 2 %
Maximum crosstalk Fz→Fy
-2 … 2 %
Metrological characteristics
Threshold
<0.002 N
Electrical properties
Output signal type
Charge (Piezoelectric, PE)
Influence quantities
Sensitivity
Fx: -26 pC/N, Fy: -13 pC/N, Fz: -26 pC/N
Certificates and Standards
Degree of protection EN 60529
IP67
Operation and installation
Operating temperature range
-20 … 70 °C
Applications
NVH testing, Cutting processes and machining development, 3C electronics manufacturing
Cable properties
Cable included
No cable included
Interfaces
Connector type
Fischer 104 9-pin (negative)
Dimensions and materials
Weight
1.35 kg
This is a multicomponent dynamometer for measuring the three orthogonal components of a force. Its very low threshold and the high sensitivity allow for measuring extremely small forces. The following machine adapters are available: machine adapters (right, left and straight) for disk-type turrets with VDI ø16 mm, ø20 mm, ø25 mm and ø30 mm, Coromant Capto C3, C4 and C5, as well as HSK-T63. In addition to the machine adapters there are the following tool holders available: tool holders for external turning tools sized 8 mm x 8 mm, 10 mm x 10 mm, 12 mm x 12 mm, 16 mm x 16 mm, 20 mm x 20 mm, 0.31" x 0.31", 0.38" x 0.38", 0.5" x 0.5" and 0.63" x 0.63", as well as tool holders for internal turning tools sized ø8 mm, ø10 mm, ø12 mm, ø16 mm.
Data sheet
English
pdf
Please click here to log in to myKistler and you will be redirected.
English
pdf
Please click here to log in to myKistler and you will be redirected.
Manual
MiniDyn Multicomponent Dynamometer up to 4 000 N
English
pdf
Please click here to log in to myKistler and you will be redirected.
MiniDyn Multicomponent Dynamometer up to 4 000 N Type 9119AA1
English
pdf
Please click here to log in to myKistler and you will be redirected.
0 results
Accessory Type