Piezoelectric force sensor SlimLine, ring force transducer (Fz 26 kN / 5.84 klbf), cable length 2 m / 9134C21
- Piezoelectric force sensor SlimLine with a measuring range of Fz: 0 ... 26 kN (5.84 klbf)
- Dimensions D x d x H: 20 x 8.1 x 3.5 mm
- Connector: KIAG 10-32 pos. int.
- Cable length: 2 m
Preloaded sensorNoMaximum measuring range26 kNRecommended preloading force5.2 kNAxial stiffness5.9 kN/μmShear stiffness2.1 kN/μmInsulation resistance≥10^13 ΩCase materialDIN 1.4542Overload30 kNOperating temperature range-20 … 120 °COutput signal typeCharge (Piezoelectric, PE)Cable length2 m
Measuring range0 … 26 kNForce sensor typeSingle axis force sensorMaximum bending moment Mxy (single load)35 NmBending stiffness2.303 kNm/°Torsional stiffness2.348 kNm/°Mass5 gNominal sensitivity–4.2±0.3 pC/NTemperature coefficient of sensitivity–0.02 %/°CLinearity≤±1 %FSODegree of protection EN 60529IP65ApplicationsSpot welding process monitoring, NVH testing
Piezoelectric force sensor, also known as piezoelectric ring force transducer, with extremely flat design for precisely measuring compression forces. Maximum resolution capacity, high stiffness and extremely compact dimensions enable ideal installation in mechanical structures. The case is hermetically sealed and has an integrated, splash-proof connecting cable with connector. This piezoelectric force sensor SlimLine is supplied uncalibrated and must be calibrated in situ after mounting for absolute measurements.The force Fz to be measured acts on the piezoelectric force sensor via the preloaded or mounting structure and produces a charge that is directly proportional to the force. This is measured by an electrode integrated in the ring force transducer and fed to the charge amplifier via the integrated cable. Because of their exceptional stiffness, SlimLine sensors are especially well suited for measuring dynamic forces. Cyclic measurements or measurements over several minutes are also possible, however. The sensor is especially well suited for measuring forces in shunt mode. This means that the sensor is embedded and preloaded in a structure. As a result, it is loaded with only part of the process force. Its especially small size is ideally suited for installation in structures such as force plates, fitting strips and tools. The sensor is used in industrial production processes in which forces are monitored or measured. Used in combination with a ControlMonitor, the sensor is ideal for quality control and monitoring.
Piezoelectric force sensor SlimLine – Piezoelectric ring force transducers for tensile and compression forces from 3 kN to 80 kN
Piezoelectric Force Sensors, Ring Force Transducers
Industrial charge amplifiers for manufacturing applications (ICAM), 1 to 4 channels (±10 V / 4 … 20 mA)
Laboratory charge amplifiers, 1-channel, low noise, measuring ranges ±2 to ±2200000 pC, freq. range ≈0 … 200 kHz
Laboratory charge amplifiers, multi-channel, low noise, measuring ranges ±2 to ±2200000 pC, freq. range ≈0 … 200 kHz
Laboratory charge amplifier, multi-channel, low noise, measuring ranges from ±2 to ±2200000 pC