Home/Products/Connectivity and accessories/Cables/Connecting cables for piezoelectric sensors, KIAG 10-32 pos. int. - BNC pos./1939ASP

Connecting cable for piezoelectric sensors, KIAG 10-32 pos. int. - BNC pos., length 0.1 to 20 m / 1939ASP

Connecting cable for piezoelectric sensors, KIAG 10-32 pos. int. - BNC pos., length 0.1 to 20 m
Connecting cable for piezoelectric sensors, KIAG 10-32 pos. int. - BNC pos., length 0.1 to 20 m
Connecting cable for piezoelectric sensors, KIAG 10-32 pos. int. - BNC pos., length 0.1 to 20 m
1939ASP
18000904
  • Length: custom (0.1 to 20 m)
  • Temperature range: –55 to +200°C
  • Sensor connection: KIAG 10-32 pos. int (IP65)
  • Amplifier connector: BNC pos. (IP40)
Upon request
On request
Configure
Mechanical properties
Bending radius [mm]
5 mm
Certificates and Standards
Degree of protection EN 60529
IP65, IP40
Operation and installation
Temperature range
-55 … 200 °C
Cable properties
Configurable cable length
0.1 … 20 m
Interfaces
Connection type (sensor)
KIAG 10-32 pos.
Connection type (amplifier)
BNC pos.
Green, single-wire, high insulation, PFA based cable (ø2 mm) for sensors with KIAG 10-32 neg. int. connector. Charge mode, high impedance piezoelectric measurement demands highly insulated coaxial cables and connectors to ensure an insulation resistance greater than 1013 Ω throughout the measuring chain. Only low noise coaxial cables that produce very little triboelectricity during movement may be used. The connectors must be robust, sealed and resistant to dirt.
Loading
Loading